工学 >>> 光学工程 >>> 光电子技术 光信息技术 光学仪器及技术
搜索结果: 1-13 共查到光学工程 Standard相关记录13条 . 查询时间(0.218 秒)
The automatic registration of terrestrial laser scans appears to be a solved problem in science as well as in practice. However, this assumption is questionable especially in the context of large proj...
Three-dimensional visualisations are an interesting method for representing model outcomes. But most visualisation techniques require expensive software, and a lot of time to create them. When a lar...
This letter proposes and experimentally demonstrates a cost-effective phase-modulation duobinary modulation scheme for improving self-phase modulation tolerance using a single modulator. Successful tr...
Bi-directional CWDM radio-over-fiber transmission of triple-format full-standard OFDM signals in coexistence (UWB, WiMAX and LTE) (1.178 Gbit/s full-duplex) is demonstrated over 50.6 km SSMF in passiv...
Dispersion pre-distorted 40-Gbit/s 16QAM transmissions over 800-km standard-single mode fiber(~13300 ps/nm) using delay detection is demonstrated with large tolerance to laser phase noise (1-MHz linew...
We experimentally demonstrate 1-Tb/s CO-OFDM transmission over 1040-km standard single-mode fiber using 50% overhead girth-12 LDPC-coded 16-QAM. More than 4-dB improvement in OSNR sensitivity is achie...
Current lab assessment shows standard 10G Ethernet link fault sequence ordered-set works as expected between two direct attached clients. This paper evaluates the limitations applying the same ordered...
Recently revised ITU-T G.709 defines a container for 100 Gbps signals called an OTU4. This paper highlights some of the reasons the OTU4 bit rate, frame structure, and mapping scheme were chosen.
A Si APD was fabricated by standard 0.18 μ m CMOS process. The maximum avalanche gain was 224 for only 8 V bias. The bandwidth was 1.6 GHz for low avalanche gain and 800 MHz for large avalanche gain.
Details of a local oscillator distribution system over 110 km of installed fibre with an r.m.s. stability of, 1 ps in 1 second, 2 ps in 1 minute and 4 ps in 10 minutes.
A 10.7 Gb/s electronic predistortion transmitter using FPGA based real-time 2 Sa/bit digital signal processing and experimental results demonstrating 800 km transmission over uncompensated SSMF are de...
We show hardware-in-the-loop experiments for 1.25 Gbit/s Transmission over SI-POF over up to 75m using LEDs with predistorted PAM4 signalling and fractionally-spaced equalisation.
We demonstrate 100-km transmission of a 40-Gbit/s 16-QAM signal using a digital coherent receiver. The receiver sensitivity of -30 dBm is obtained at BER=10 -5

中国研究生教育排行榜-

正在加载...

中国学术期刊排行榜-

正在加载...

世界大学科研机构排行榜-

正在加载...

中国大学排行榜-

正在加载...

人 物-

正在加载...

课 件-

正在加载...

视听资料-

正在加载...

研招资料 -

正在加载...

知识要闻-

正在加载...

国际动态-

正在加载...

会议中心-

正在加载...

学术指南-

正在加载...

学术站点-

正在加载...