搜索结果: 1-8 共查到“医学 Temperature rise”相关记录8条 . 查询时间(0.089 秒)
Effects of LEDs on Microhardness and Temperature Rise of Dental Composite Resins
LEDs Composite resins Microhardness
2009/9/14
The purpose of this study was to examine the effects of LEDs on the polymerization of dental composite resins. Three composite resins and two LED units were used to evaluate the latter's effects on mi...
Effects of Light Curing Modes and Resin Composites on Temperature Rise under Human Dentin: An in vitro Study
Temperature rise Composites Polymerization
2009/9/11
The influence of three curing modes of a high-powered LED curing unit on temperature rise under 2-mm-thick dentin was investigated during the polymerization of resin composite samples of Admira, Filte...
Temperature Rise under Normal and Caries-Affected Primary Tooth Dentin Disks during Polymerization of Adhesives and Resin-containing Dental Materials
Temperature rise Caries-affected primary tooth dentin Photopolymerization
2009/9/11
The purpose of this study was to compare the temperature rise under normal and caries-affected primary tooth dentin during photopolymerization of two adhesives and resin-containing restorative materia...
Temperature rise induced by various light curing units through human dentin
Light curing units Temperature rise Dentin
2009/9/11
This study investigated temperature rises caused by different light curing units (LCUs) in dentin of different thicknesses. The different LCUs tested in this study were namely: quartz-tungsten-halogen...
Influence of Light Curing Unit and Ceramic Thickness on Temperature Rise during Resin Cement Photo-activation
Ceramic thickness Photo-activation methods Temperature increase
2010/12/1
The aim of this study was to determine the effect of different ceramic thickness on heat generation during resin cement photo-activation by QTH (quartz-tungsten-halogen), LED (light emitting diode), a...
Temperature Rise During Orthodontic Bonding With Various Light-curing Units—An In Vitro Study
Temperature rise Pulp chamber Orthodontic bonding Light curing
2008/11/19
The purpose of this in vitro study was to investigate the temperature changes in the pulp chamber during bracket bonding using three different light sources. Bracket bonding was performed on one...
Temperature Rise in the Pulp Chamber duringDifferent Stripping Procedures
Stripping Temperature Pulp chamber Thermocouple
2008/11/5
Objective: To measure the temperature changes in the pulp chamber when different stripping procedures were used without any type of coolant.Materials and Methods: Ninety intact, freshly extracted huma...
A CONTROLLED INTERVENTION STUDY CONCERNING THE EFFECT OF INTENDED TEMPERATURE RISE ON HOUSE DUST MITE LOAD
Dermatophagoides house dust mites humidity intervention season
2010/12/24
In epidemiological studies, increased indoor temperature - producing a lower relative humidity - is associated with low house dust mite (HDM) load. Twenty-eight dwellings were allocated for either int...